Code Search

Please fill the "Code Box" to find engine fault code.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

Other Mazda Cars:

Mazda Clef P0306 Engine Trouble Code

Theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

Mazda Clef P0306 Code Meaning :

P	0	3	0	6
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine	Intake Valve Control Solenoid Circuit Low	Throttle/Pedal Position Sensor/Switch A Circuit Intermittent	Cold Start Injector 1 Malfunction	Ignition Coil A Primary/Secondary Circuit Malfunction

When you check Mazda Clef car engine light came on code P0306 the reason should be Engine Light ON (or Service Engine Soon Warning Light). However manufacturer may have a different definition for the P0306 OBD-II Diagnostic Powertrain (P) Trouble Code. So you should chech it on our car models.

P0306 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for P0306 code is occuring now you should check P0306 repair processes.
Now don't ask yourself; What should you do with P0306 code ?
The solution is here :

Mazda Clef P0306 Possible Solution :

Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.

P0306 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P0306 OBD-II Trouble Code When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the Crankshaft Position (CKP) sensor signal to vary, the Engine Control Module ( P0306 code.

Reason For P0306 Code

The reason of P0306 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

Parts or components should not be replaced with reference to only a P0306 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

	Example: 0120